Switch# copy t flash:ĭestination filename ? Skip this step if you want to use the new The filename is specified relative to the directory used for file transfers. The location is either an IP address or a host SUCCESS: install_remove Mon Nov 14 17:47:Ĭopy tftp: /directory]/filename flash: Use this command to copy the new image from a TFTP server to flash memory. Finished Post_Remove_Cleanup on switch 1Ĭhecking status of Post_Remove_Cleanup on Post_Remove_Cleanup package(s) on switch 1 Performing Post_Remove_Cleanup on all members done.ĭo you want to remove the above files? yĭeleting file flash:cat9k_lite_iosxe.17.09.01.SPA.bin. No path specified, will use booted path flash:nf The following sample output displays the cleaning up of unused files, by using the install remove inactive command: Switch# install remove inactive Of space in flash, to expand a new image. Use this command to clean-up old installation files in case of insufficient space and to ensure that you have at least 1GB The sample output in this section displays upgrade from Cisco IOS XE Cupertino 17.9.1 to Cisco IOS XE Dublin 17.10.1 using install commands only. Note that you can use this procedure for the following upgrade scenarios:Ĭisco IOS XE Cupertino 17.9.x or earlier releases Must be booted into IOS through boot flash:nf. Rolls back the update to the last committed version.Ĭancels file activation, and rolls back to the version that was running before the current installation procedure started.ĭeletes all unused and inactive software installation files.įollow these instructions to upgrade from one release to another, in install mode. The auto-abort-timer keyword automatically rolls back image activation. To separately install, activate, commit, cancel, or remove the installation file: install ?Ĭopies the install file package from a remote location to the device and performs a compatibility check for the platform andĪctivates the file, and reloads the device. To install and activate the specified file, and to commit changes to be persistent across reloads: Summary of Software Installation Commands The updated boot loader supports all previous releases.ĭo not power cycle your switch during the upgrade. If you go back to the older release after this, the boot loader is not downgraded. If the boot loader is automatically upgraded, May be automatically upgraded, based on the hardware version of the switch. When you upgrade from the existing release on your switch to a later or newer release for the first time, the boot loader You can also use the dir filesystem: privileged EXEC command to see the directory names of other software images that you might have stored in flash memory. You can use the show version privileged EXEC command to see the software version that is running on your switch.Īlthough the show version output always shows the software image running on the switch, the model name shown at the end of this display is the factoryĬonfiguration and does not change if you upgrade the software license. The package files for the Cisco IOS XE software are stored on the system board flash device (flash:).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |